838 products in our shop!
Categories
10 years anniversary!
twitter
Follow shop01media on Pinterest
facebook
team-executer-reseller
Sky3DS
Gateway
supercard
r4-3ds
Cobra
x3key
hd-fury
Out of stock!
Enter your email to be informed when this product arrives:


Send Close
Out of stock!
Enter your email to be informed when this product arrives:
Send Close
Special bundle price:
Credit Card payments
World Wide Shipping
World Wide Shipping
Category           » XBOX 360  / Repair parts & tools  / Mod Tools  / Development Boards
Brand           » Digilent

Digilent JTAG-HS1 USB programmer

In Stock
51.74 €

2 or more 49.39 €
Digilent Product Code: JTAG-HS1
Weight: 0.043kg

Digilent JTAG-HS1 USB programmer

The JTAG-HS1 programming cable is a high-speed programming solution for Xilinx FPGAs. It is compatible with all Xilinx tools, including iMPACT, Chipscope, and EDK.

The HS1 attaches to target boards using Digilent’s 6-pin, 100-mil spaced programming header, or Xilinx’s 2x7, 2mm connector (using the included adaptor).

The JTAG-HS1 is powered from a PC’s USB port.

The HS1 can be seamlessly driven from Xilinx’s iMPACT software or from Digilent’s Adept software. It will be recognized as a Digilent programming cable when connected to a PC, whether or not it is attached to the target board. A separate Vdd pin is provided on the HS1 to supply JTAG signal buffers. These high speed, 24mA, three-state buffers allow target boards to use JTAG signal voltages from 1.8V to 5V, with bus speeds of up to 30MBit/sec.

The HS1’s Vdd pin must be tied to the same voltage supply that drives the JTAG port on the FPGA.

JTAG signals are held in high-impedance except when actively driven during programming, so the JTAG bus can be shared with other devices. The HS1 uses a standard Type-A to Micro-USB cable (included with the HS1) that attaches to the end of the module opposite the system board connector. The HS1 is small and light, allowing it to be held firmly in place by the system board connector.

Note for use with Adept: The JTAG-HS1 requires Adept System 2.8.1 or newer for use in Windows, and Adept Runtime 2.8.2 or newer for use in Linux.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



This site and all contents are © 2002-2009 01Media.
All Registered Trade Marks used on this Website, whether marked as Trade Marks or not marked, are declared to belong to their respective owner(s).