|Category||» XBOX / Mod Chips|
One of the most feature-packed low budget mod chips for Xbox. Reliable and easy to install.
The Aladdin Advance XT is compatible with all XBOX models, including the V1.6B. Microprocessor controlled functions: can be disabled for XBOX LIVE and flash protected via XBOX power and eject buttons. Modchip modes are shown via different colours on the XBOX eject button LED. Flash upgradable via CD-RW / DVDR and EvolutionX dashboard. Also supports quick solder and Pinheader install options.
This model have 4032 chip.
NOTE: The Aladdin XT PLUS2 comes flashed with Evox M8+ BIOS M8plus_16.bin which was developed for Xbox v1.6-1.6b but can also be installed/booted in Xbox v1.0-1.5, however, we recommend you flash a BIOS intended for these versions (e.g. M8plus.bin).
This chip only requires 8 pins in the header you solder into the motherboard.
The picture shows with RED Crosses the pins that can be removed. The header goes in from the front end of the mother board and the vacant holes are at the back end of the mother board closest to the back of the mother board. You should have 4 vacant holes when you have the header in the board. This are the only pins that really need to be in on an Aladdin. You can of course keep all pins in place except the one that needs to be out just in case the machine ever has a different type of chip put in.
Hook it up like this and it will boot everytime you start the machine. No need to ever turn the chip off because XboxLive is not an issue any longer and it also saves you needing to hook up the "BT" and "LT" wires. You only need to hook up the "D0" wire. The D0 point is recommended to be on the underside of the board. It is the easiest one to solder to and running the wire through one of the unused holes in the LCP connector, (where you solder the header in), makes for a neat install.