|Category||» XBOX 360 / Repair parts & tools / Tools and parts|
Professional tool for all your Xbox 360 home brew needs.The nandflasher is basically a JTag device that lets you read and write to the X360 NAND.
NOTE: This requires an Exploitable console (odl dashboard) OR for latest dashbords you need to use RGH2 (glitcher in each console you flash).
Compatible with Nandpro v2.0d for reading and writing to all mainboard versions (Xenon, Falcon, Zephyr, Opus, & Jasper) on consoles that are xploitable, meaning kernel 7xxx or lower, manufactured before Jun 18, 2009 and has not been to a a MS repair center since June 12, 2009
Every kit comes with a set of quicksolder boards for 1 install. We offer also aditional quicksolder modules.
>> Instructions for wire plugs.
Information regarding the resistor reqired for some consoles:
This nandflasher have the resistor, it is in paralell with the solder bridge wich could look empty to the eye. This is to make the install easy.
The resistor is required for some consoles mainly zephyr but will not harm having them for all others, thats why we leaved it as default.
It is possible to bypass it go with direct connection just bridge the jumper above the resistor (no need to remove the resistor). The bridging is just needed for a few amount of consoles that will require bypass the resistor, for the 99% of the consoles leaving the default is safe and tested
NOTE: Return policy for all flashing tools and similar tools:
NO returns and refounds, only exchange if deffective.