Switch for all the Liteon drives that enables firmware full read/write. For use with Liteon 74850 83850 93450.Switch for all the Liteon drives that enables firmware full read/write. For use with Liteon 74850 83850 93450.
This kit has been designed with the beginner in mind.
It is been in development for a while due to the absolute precision and stability needed to make sure it works for the the lifetime of the DVD Drive with no soldering or glue for trace repairs.
We have even included a built in continuity tester to make sure your trace cuts are perfect.
Installation is simple. Make 3 trace cuts (The same as LT Switch v1.X), fit the LT Clip PCB to the Liteon PCB and use the continuity test button to make sure your cuts are correct (Green LED = Good, Red LED = bad). Once you have a Green LED you then fit the specially designed clip to fix the PCB in place. That’s it !
The LT Clip can be used with either the new LT Switch v2 or the CK3 Probe II.
- If you are skilled and can solder then you can use the LT Switch v1.5
- If you are a multiple modder who can solder but wants to be fast and cost effective then you have the CK3 Probe II
- If you are a beginner who has no soldering skills or equipment, doesn’t want to buy or use conductive glue and doesn’t want the expense to post their console to someone for modding – then the LT Clip solution is perfect for you.
They have also included an On/OFF Led to show correct operation when switching to 0x72 vendor mode.
It has been tested with the original DOSFLASH methods and also the new Jungle Flasher 0.1.69. All Liteon drive versions have been tested with 100% Success. There is no need to remove the LT Switch after it has been installed - simply switch to normal mode.
Enables Read/Write on Liteon 74850, 83850, 93450 DVD Drives
Enable / Disable Switch
No Need To Uninstall
Works with all tools including latest Jungle Flasher
Redesigned circuit to give a cleaner filter when switching to Vendor mode. No more read errors !
Enlarged solder points to give an easier flow to the Liteon PCB points – Noob friendly !
Added Read/Write Mode LED (RED)
Added Normal 360 Mode LED (Green)
Upgrade the switch to a stronger more robust model
Changed location of LED so they can be viewed when Liteon PCB is installed to its case
Slight improvement to the PCB shape so it sits firmly and accurately in place when soldering.
>> Full instructions on how to install and use the LT Clip & LT Switch v2.
This device is designed primarily to aid or assist in the repair or replacement of defective hardware and also for the use of and development of legal open source software. It does not enable any kind of piracy or have any code whatsoever that circumvents any kind of protection.